The network topology diagram (Figures 1) shows the test setup for end-to-end interoperability between Cisco Unified Communications Manager Release 7.1 connected to the Siemens HiPath PBX using SIP trunks via IP connectivity.This application note describes the necessary steps and configurations for connectivity between a Siemens HiPath 4000 Release 3.0 and a Cisco Unified Communications Manager (CUCM) 7.1 over SIP trunk using Cisco IOS Gateway.
Important notices, privacy statements, and trademarks of Cisco Systems, Inc. Hardware Components.5 Software Requirements.5įeatures.6 Features Supported.6 Features Not Supported (See limitations).6Ĭonfiguration.7 Configuring the Siemens HiPath 4000 PBX.7 Configuring the Cisco Unified Communications Manager. Introduction.2 Network Topology.3 Limitations.4 System Components.5 Table of ContentsTable of ContentsTable of ContentsTable of Contents Siemens HiPath 4000 Release 3.0 using SIP trunk to Cisco Unified Communications Manager 7.1 7 Configuring the Cisco Unified Communications Manager. 7 Configuring the Siemens HiPath 4000 PBX. 6 Features Not Supported (See limitations).
can be found on of 61 EDCS# 792395 Initial Revision Application Note Siemens HiPath 4000 Release 3.0 using SIP trunk to Cisco Unified Communications Manager 7.1 August 15th 2009, Initial Version Table of Contents Table of Contents Table of Contents Table of Contents Introduction.
0 kommentar(er)
